Antinsky ColdPlate Craft consistent output

consistent output

hoher Glanz

you can flexibly relocate the feeder units of your Snapmaker U1

Almost no delay

13 g/cm³ Tensile Strength 72 MPa Heat Deflection Temperature 175 °C Drying Conditions 80 °C / 4h Surface Resistance 10¹⁴ Ω

Antinsky ColdPlate Craft consistent outputThe Antinsky Cold PEI Plate is a flexible PEI print bed for FDM printers, designed for reliable adhesion at low bed temperatures. This allows you to start up faster, save energy, and reduce warping without constantly heating the bed to high temperatures. Particularly practical: After printing, the part is often easier to remove if the bed has cooled down to approximately 30 C. For slicer settings, Antinsky recommends Cool plate as the plate type for