Always work it in that way anytime youre completing a run
You will feel entirely at ease whether you are casting or fighting with your next catch

Another shot Another shot Last shot before starting on restoration Removing old line Ready to begin Most post screws stuck Punching out gear sleeve keeper pin Disassembled Parts split up -- left side goes in Simple Green (handle would also go in the green -- but it is shot and needs replacement) -- right side goes in purple HD Degreaser -- all ready for 6 minutes in the Ultrasonic Cleaner Cleaning area Ultrasonic Cleaner -- Purple in the front vat -- Simple Green in the rear -- 6 minutes total time -- pour into a strainer -- ready for fresh water rinsing Fresh warm water rinse Air drying after rinse Ready and staged for reassembly HT-100 CF drags, SS drag washers, new hard under gear washer, new spring washer Drags coated liberally with drag grease (either Cal's or Shimano) Grease all inside moving parts with Yamaha Marine Grease -- if it is done now -- the final assembly is smoother and quicker -- also do all screws, inside of rings, inside of plates, jack, yoke, pinion gear, main gear, clicker assembly

The width means the center of gravity ends up being much lower, so you wont feel like the pack is pulling you backwards
It is part of Daiwas eco-friendly D-Box