G01000 - SEMI G10 - Standard Method for Mechanical Measurement of Plastic Package Leadframes StdPbc-0317 The resistivity of a semiconductor

The resistivity of a semiconductor material is an important materials acceptance requirement

注意: 　本文書は，編集上の修正を伴い，再承認された。

The intent of this Document is not to suggest any specific testing program but to specify the test method to be used when testing for parameters that are covered by this method

or prohibit asynchronous messages sent by the Carrier ID Reader or Reader/Writer

1-0299 (technical revision)

G01000 - SEMI G10 - Standard Method for Mechanical Measurement of Plastic Package Leadframes StdPbc-0317 The resistivity of a semiconductorNOTICE: This Standard or Safety Guideline has an Inactive Status because the conditions to maintain Current Status have not been met. Inactive Standards or Safety Guidelines are available from SEMI and continue to be valid for use. This method outlines standard mechanical measurement techniques for cut strip leadframes. This method applies to all facilities that perform mechanical measurements on leadframes. Information is provided herein to enable