RAG JOINT,13/16-36 X 1"-48 Upper and Lower Arm Sets - Stock you are required to cut

you are required to cut out the hole in the a-arm before inserting this ball joint

WEIGHS APPROXIMATELY 12

IMCA approved

Chrome Plated Steel

USED IN #101-621 PREMIER UPPER A-ARMS

RAG JOINT,13/16-36 X 1"-48 Upper and Lower Arm Sets - Stock you are required to cutBRAND NEW SOUTHWEST SPEED STEERING RAG JOINT. IT IS ALWAYS A GOOD IDEA TO REPLACE THE RAG JOINT WHEN DOING ANY WORK ON THE STEERING SYSTEM. RAG JOINTS PROVIDE A SMALL AMOUNT OF FLEX FOR A STEERING SHAFT WITHIN A FEW DEGREES OF THE SAME PLANE AS THE STEERING GEAR INPUT SHAFT. THEY ALSO PROVIDE SOME DAMPING OF VIBRATION COMING FROM THE STEERING SYSTEM, PROVIDING SOME ISOLATION FOR THE STEERING WHEEL. THESE JOINTS WILL WEAR OVER TIME, SO REPLACING THEM