RAG JOINT,3/4-36 X 1"-48 Torque-Link Coil Springs ALUMINUM WEIGHT JACK PLATE THAT

ALUMINUM WEIGHT JACK PLATE THAT FITS 5" OUTSIDE DIAMETER FRONT SPRINGS

THEN YOU DONT HAVE TO WORRY ABOUT IDENTIFYING THE BOX BECAUSE THIS ARM SHOULD BE THE ONE TO FIT IT

*CENTER OF LEFT SIDE INNER TIE ROD END HOLE TO CENTER OF RIGHT SIDE INNER TIE ROD END HOLE: 12 7/8"

On these 55-57 Chevy's

& Bumpers (Part #101-93887 & #101-95887)

RAG JOINT,3/4-36 X 1"-48 Torque-Link Coil Springs ALUMINUM WEIGHT JACK PLATE THATBRAND NEW SOUTHWEST SPEED STEERING RAG JOINT. IT IS ALWAYS A GOOD IDEA TO REPLACE THE RAG JOINT WHEN DOING ANY WORK ON THE STEERING SYSTEM. RAG JOINTS PROVIDE A SMALL AMOUNT OF FLEX FOR A STEERING SHAFT WITHIN A FEW DEGREES OF THE SAME PLANE AS THE STEERING GEAR INPUT SHAFT. THEY ALSO PROVIDE SOME DAMPING OF VIBRATION COMING FROM THE STEERING SYSTEM, PROVIDING SOME ISOLATION FOR THE STEERING WHEEL. THESE JOINTS WILL WEAR OVER TIME, SO REPLACING THEM